ST-712 Inline pH + ORP Sensor

One Sensor. Two Vital Parameters.

A simple to use inline sensor that measures for both pH (0–14 pH Value) and ORP (±1,500mV Range). Built robustly for Industrial Water Treatment applications!

CE Mark

$930.00

Description

The ST-712 an inline dual-channel pH + ORP sensor that is specifically designed to simplify installation, calibration and operation in process, industrial, waste and cooling water applications. This sensor offers an embedded transmitter and can be utilized in both 4–20mA or RS-485 Modbus formats. When used in RS-485 format, the ST-712 also provides a temperature output signal. These features dramatically improve application possibilities allowing the ST-712 to be directly connected to most OEM controller, PLC or DCS systems.

The ST-712 has an oversized platinum disk for ORP and a flat pH bubble sensing element that increases resistance to highly turbid waters and contamination. The enlarged salt bridge design with large junction capacity also ensures a long sensor life with minimal maintenance. This device is ideally suited for “hard-to-measure” waters where conventional pH & ORP sensors would otherwise fail or require high maintenance costs. The ST-712 does NOT require electrode change-out or Potassium Chloride (KCl) re-fill, and is designed to be used until the end of life and then completely swapped out.

Typical Applications

  • Industrial Process & Cooling Water
  • Fresh, Brackish, Sea Water
  • Raw, Influent Water
  • Wastewater Effluent
  • Surface & Storm Water

Features

  • Dual Embedded Transmitter – 4–20mA and RS-485 supporting Modbus
  • Compact Design for Small Footprint, Ideally Suited for Industrial Applications
  • Tolerant to Frozen Conditions during Shipment or Storage
  • Large Junction Capacity (Compared to Replaceable Electrode Design) Leading to Longer Service Life and Less Maintenance
  • Stainless Solution Grounding Point on Sensor to Stay Away from Ground Loop Problems
  • Interfaces with Pyxis Lab® MA-WB Wireless Adapter or PowerPACK Auxiliary Box

Specifications

Item ST-712
Part Number 53003
pH + ORP Range 0-14 pH
±1,500mV
pH + ORP Resolution ±0.01 pH
±1.0mV
Response Time 95% within 5 Seconds
Power Supply 12-36VDC, 1W
Output 4-20mA Isolated, RS-485 Isolated
Connector IP67 Water-Proof Connector/Cable 1.5m (4.5ft)
Operation Pressure up to 0.7MPa (100psi)
Installation ST-001 3/4in Tee Assembly
MA-102S Submersion Adapter
Storage Temperature -20-60 °C (-4-140 °F)
Operation Temperature 40-120 °F (4-49 °C)
Housing Material CPVC
Dimension 6.8in (172.7mm) L, 1.44in (36.6mm) D
Weight 0.37lbs (170g)
Typical Service Life 2+ Years
Warranty 13 Months from Date of Shipment
Regulation CE / RoHS

Support Documents

ST-71X Data Sheet

Water Quality Sensor (pH, ORP, Conductivity) Start-Up Guide

Reviews

There are no reviews yet.

Be the first to review “ST-712 Inline pH + ORP Sensor”

Your email address will not be published. Required fields are marked *

You may also like…

Shopping Cart
Scroll to Top